Anaheim Automation MBC10P31 Guia do Utilizador descarregar pdf (Página 23)

#L010143 November 2003

Dimension Drawing

Figure 5: MBC10641 dimensions

Connecting the Step Motor

Phase 1 and 3 of the Step Motor is connected between pins 1 and 2 on the motor connector (TB2). Phase

2 and 4 of the Step Motor is connected between pins 3 and 4 on the motor connector (TB2). The motors

case can be grounded to pin 5 on the motor connector (TB2). Refer to Figures 2, 3 & 4 for TYPICAL

APPLICATION HOOK-UP.

NOTE: The physical direction of the motor with respect to the direction input will depend on the connection

of the motor windings. To reverse the direction of the motor with respect to the direction input, switch the

wires on Phase 1 and Phase 3.

WARNING: Do not connect or disconnect motor wires while power is applied!

Short-Circuit, Mis-Wire, and Over-Current Conditions

If it is found that there is a condition that causes on over current in the driver phase transistors, the Red

LED will turn on solid and power will be shut off to the motor. To reset the drive turn power off, check

wiring, and turn power back on.

Over-Temperature and Over-Voltage Conditions

If it is found that there is an over temperature on the internal heat sink, or an over voltage on the motor bus

voltage, the Red LED will blink and power will be shut off to the motor. To reset the drive turn power off,

check wiring, and turn power back on.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 44 45

Sem comentários

Anaheim Automation MBC10P31 Guia do Utilizador Página 23